At the bench

Workshop

At the bench

Workshop

At the bench

Workshop

From a board to an oud bowl

I choose the wood for the bowl while I can still see the whole board. With Moon Ebony, a dark streak can run through pale wood for the length of a rib. I decide where that line should travel around the bowl, then cut the ribs one at a time and keep them in sequence. As I bend and fit each rib over the mould, I check how the figure meets at the next joint.

Raw Moon Ebony before its figured wood is divided into bowl ribs.

Moon Ebony before the ribs are cut.

Numbered Moon Ebony ribs laid edge to edge to match the dark grain across the bowl.

I number the loose ribs so the grain lines stay in sequence.

The numbered Moon Ebony ribs bent over a white oud mould and held together by pins.

The pattern takes shape as I fit the ribs over the mould.

The bowl as tonewood

I choose bowl wood with the sound of the finished oud in mind. Two ribs of the same dimensions can differ in mass because their woods have different densities. Their stiffness, thickness and curvature affect how readily the shell flexes. I listen to the result in the assembled instrument, where the bowl, the soundboard and the air they enclose vibrate together.

Brazilian rosewood after sixty years as furniture

This Brazilian rosewood spent nearly sixty years as furniture before it reached my bench. I laid out the ribs to carry its figure across the back of the oud. The first photograph shows the reclaimed wood before cutting. In the second, you can follow the same grain over the curve of the finished bowl.

Reclaimed Brazilian rosewood laid out on the workbench.

The Brazilian rosewood as it came to my bench.

The finished Brazilian rosewood bowl from my April 2024 workshop record, showing the matched grain across the ribs.

The same timber in the finished bowl.

Two ways to build the soundboard

The uninterrupted grain of a single-top soundboard and the dark inlay rings around its three future soundholes.

Single top

I join two halves of solid spruce and bring the plate to thickness. Its density and stiffness help me decide how much wood to leave in the plate and how high to shape its braces. I check the plate’s vibration as the work progresses.

Double top

I prepare two thin wooden faces and a light Nomex honeycomb core, then bond them under vacuum. Separating the faces with the core gives me another way to work with stiffness and mass. The photograph shows the layers before they become a single plate.

Shellac and the weight of the finish

I weigh the oud before finishing and again between coats, after the finish has had time to dry. I follow the change in mass through the process, whether I am working with shellac or lacquer. On the soundboard, even the finish becomes part of the vibrating plate.

French polishing the soundboard

I use shellac on my soundboards. With a lightly charged pad, I work in thin passes around the soundholes and across the spruce. Watching the reflection as I move the pad helps me keep the film even and avoid a heavy build-up.

A rosewood oud bowl on the bench with the polishing pad and pumice used to fill its pores.

Choosing a finish for the bowl

For the bowl I choose French-polished shellac or a very thin synthetic lacquer, taking into account the wood and the conditions in which the oud will be played and kept. On the rosewood bowl shown here, I work pumice into the open pores with shellac before building the polish.